Cavity Wall Insulation
Quoted from SEAICASE STUDY: John has a four bedroom detached house with a footprint of 150 m2. He has an annual heating bill of €1,600. John previously had no wall insulation in his cavity walls and was advised to install grey pumped polystyrene beads [KOREFill] in his walls following advice from SEAI and various contractors he rang. As well as resulting in more comfortable living conditions, this simple measure has resulted in annual savings in his heating bill of approximately €300. John was also able to secure grant aid from the Home Energy Savings scheme to help him with the cost of this.
FACT: poorly insulated, or un-insulated walls can cost you money. On average, a home loses 20 - 30% of its heat through its walls and even more if they are not properly insulated. Brusna Energy Solutions uses the KOREFill System, which consists of expanded polystyrene material injected in bead form with an approved bonding agent into a cavity to form an insulating mass.
The bonding agent is injected through drill holes, into the cavity using specifically designed equipment at the correct material binder ratio through a flexible pipe fitted with a non directional nozzle.
>>Get A Free On Site Survey & Quotation<<
The KOREFill Cavity Wall Insulation Package
When you get Brusna Energy Solutions To Insulate Your Cavity Wall. . . You can be sure that quality comes first.
- KOREFill Bonded Bead
- Excellent U-Values Achieved
- Instant Savings On Heating Bills
- Complete Fill Every Time
- Environmentally Friendly Product
- SEAI Grant Available Of €400
- 100% Satisfaction Guarantee
- Free Survey & Quotation
>>Get A Free On Site Survey & Quotation<<
Want to Know More About The Products We Use?
As you might of noticed we are proud of the work we do and the products we use, that's because we strive to provide the very best and most advanced and innovative energy saving solutions and applications to our customers. The products we use reflects on the service we provide. Below is more detailed information on the products we use in our KOREFill Cavity Wall Insulation Package.
KORE Fill Bonded Bead Insulation
"The KOREFill System is designed for use in both new and existing buildings."
KORE Fill is a bonded bead, is a complete cavity wall fill
insulation system, the insulation system can be applied in new and existing
buildings. KORE Fill is expanded polystyrene and special
bonding agent injected in bead form into a cavity to form
an insulating mass.The U-value of KOREFill is only prohibited by the width of the cavity. A 110mm cavity will achieve a U-value of 0.27 W/m²K while a 150mm cavity will achieve 0.20W/m²K.
The natural matrix formed by the bead means that moisture that penetrates the outer leaf will not travel through the cavity to the inner leaf. The water by natural gravity will flow to the weep holes at the bottom of the cavity. The bead bond together in a honeycomb type formation this allows air to circulate and the cavity to breath. The bead is an advanced grade of polystyrene; each individual bead is coated in graphite and greatly increases the thermal conductivity of the product.
Still want to know more about the KOREFill product?
Click Here To Visit Our Documents & Links Section
